| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354 |
- ST_FAMILY = l0
- DEPS_SUBMODULES += lib/CMSIS_5 hw/mcu/st/cmsis_device_$(ST_FAMILY) hw/mcu/st/stm32$(ST_FAMILY)xx_hal_driver
- ST_CMSIS = hw/mcu/st/cmsis_device_$(ST_FAMILY)
- ST_HAL_DRIVER = hw/mcu/st/stm32$(ST_FAMILY)xx_hal_driver
- CFLAGS += \
- -flto \
- -mthumb \
- -mabi=aapcs \
- -mcpu=cortex-m0plus \
- -mfloat-abi=soft \
- -nostdlib -nostartfiles \
- -DSTM32L053xx \
- -DCFG_EXAMPLE_MSC_READONLY \
- -DCFG_EXAMPLE_VIDEO_READONLY \
- -DCFG_TUSB_MCU=OPT_MCU_STM32L0
- # mcu driver cause following warnings
- CFLAGS += -Wno-error=unused-parameter -Wno-error=maybe-uninitialized -Wno-error=redundant-decls
- # All source paths should be relative to the top level.
- LD_FILE = hw/bsp/$(BOARD)/STM32L053C8Tx_FLASH.ld
- SRC_C += \
- src/portable/st/stm32_fsdev/dcd_stm32_fsdev.c \
- $(ST_CMSIS)/Source/Templates/system_stm32$(ST_FAMILY)xx.c \
- $(ST_HAL_DRIVER)/Src/stm32$(ST_FAMILY)xx_hal.c \
- $(ST_HAL_DRIVER)/Src/stm32$(ST_FAMILY)xx_hal_cortex.c \
- $(ST_HAL_DRIVER)/Src/stm32$(ST_FAMILY)xx_hal_rcc.c \
- $(ST_HAL_DRIVER)/Src/stm32$(ST_FAMILY)xx_hal_rcc_ex.c \
- $(ST_HAL_DRIVER)/Src/stm32$(ST_FAMILY)xx_hal_gpio.c
- SRC_S += \
- $(ST_CMSIS)/Source/Templates/gcc/startup_stm32l053xx.s
- INC += \
- $(TOP)/lib/CMSIS_5/CMSIS/Core/Include \
- $(TOP)/$(ST_CMSIS)/Include \
- $(TOP)/$(ST_HAL_DRIVER)/Inc \
- $(TOP)/hw/bsp/$(BOARD)
- # For freeRTOS port source
- FREERTOS_PORT = ARM_CM0
- # For flash-jlink target
- JLINK_DEVICE = STM32L053R8
- # Path to STM32 Cube Programmer CLI, should be added into system path
- STM32Prog = STM32_Programmer_CLI
- # flash target using on-board stlink
- flash: $(BUILD)/$(PROJECT).elf
- $(STM32Prog) --connect port=swd --write $< --go
|
