menu "Hardware Drivers Config"

    menu "Onboard Peripheral Drivers"

    endmenu

    menu "On-chip Peripheral Drivers"

        rsource "../../libraries/HAL_Drivers/drivers/Kconfig"

        menuconfig BSP_USING_UART
            bool "Enable UART"
            default y
            select RT_USING_SERIAL
            select RT_USING_SERIAL_V2
            if BSP_USING_UART

                menuconfig BSP_USING_UART9
                    bool "Enable UART9"
                    default n
                    if BSP_USING_UART9
                        config BSP_UART9_RX_USING_DMA
                            bool "Enable UART9 RX DMA"
                            depends on BSP_USING_UART9 && RT_SERIAL_USING_DMA
                            default n

                        config BSP_UART9_TX_USING_DMA
                            bool "Enable UART9 TX DMA"
                            depends on BSP_USING_UART9 && RT_SERIAL_USING_DMA
                            default n

                        config BSP_UART9_RX_BUFSIZE
                            int "Set UART9 RX buffer size"
                            range 64 65535
                            depends on RT_USING_SERIAL_V2
                            default 256

                        config BSP_UART9_TX_BUFSIZE
                            int "Set UART9 TX buffer size"
                            range 0 65535
                            depends on RT_USING_SERIAL_V2
                            default 0
                    endif
            endif


        menuconfig BSP_USING_HW_I2C
            bool "Enable hardware I2C BUS"
            select RT_USING_I2C
            default n
            if BSP_USING_HW_I2C
                config BSP_USING_HW_I2C1
                    bool "Enable Hardware I2C1 BUS"
                    default n
                config BSP_USING_HW_I2C2
                    bool "Enable Hardware I2C2 BUS"
                    default n
            endif
        
        menuconfig BSP_USING_SPI
            bool "Enable SPI BUS"
            default n
            select RT_USING_SPI
            if BSP_USING_SPI 
                config BSP_USING_SPI0
                    bool "Enable SPI0 BUS"
                    default n
                config BSP_USING_SPI1
                    bool "Enable SPI1 BUS"
                    default n
            endif
    
    endmenu

    menu "Board extended module Drivers"

    endmenu
endmenu