| 123456789101112131415161718192021222324252627282930313233 |
- # SPDX-License-Identifier: GPL-2.0-or-later
- # Knovative KC-100 cable modem
- # TNETC4401PYP, 208-QFP U3
- source [find target/tnetc4401.cfg]
- # 14-pin EJTAG on JP1. Standard pinout, 1-3-5-7-9-11 = nTRST-TDI-TDO-TMS-TCK-nSRST. Use 2 for GND.
- # Was initially disabled in hardware; had to add a solder bridge reenabling R124, R125 on back.
- reset_config trst_and_srst separate
- # 16Mb Intel CFI flash. Note this CPU has an internal ROM at 0x1FC0000 (phys) for cold boot.
- # All that really does is some minimal checks before jumping to external flash at 0x00000000 phys.
- # That is remapped to 0xB0000000 uncached, 0x90000000 cached.
- flash bank intel cfi 0xB0000000 0x200000 2 2 $_TARGETNAME
- # Perform this after a clean reboot, halt, and reset init (which should also leave it halted).
- proc kc100_dump_flash {} {
- echo "Probing 48 TSOP Intel CFI flash chip (2MB)..."
- flash probe intel
- echo "Dumping 2MB flash chip to flashdump.bin.
- flash read_bank 0 flashdump.bin 0 0x200000
- }
- #TODO figure out memory init sequence to be able to dump from cached segment instead
- # There is also a serial console on JP2, 3-5-6 = TX-RX-GND. 9600/8/N/1.
- # Possibly of note, this modem's ancient ethernet port does not support Auto-MDIX.
- # This modem in many ways appears to be essentially a clone of the SB5120. See usbjtag.com.
- # The firmware/OS is also susceptible to many of the same procedures in "Hacking the Cable Modem"
- # by DerEngel (Ryan Harris), available from No Starch Press.
|
