esp-idf/examples/zigbee/light_sample/HA_on_off_light

Supported Targets	ESP32-H4

Light Bulb Example

This test code shows how to configure Zigbee end device and use it as HA on/off light bulb

Hardware Required

• One development board with ESP32-H4 SoC acting as Zigbee end device (loaded with HA_on_off_light example)
• A USB cable for power supply and programming
• Choose another ESP32-H4 as Zigbee coordinator (see HA_on_off_switch example)

Configure the project

Before project configuration and build, make sure to set the correct chip target using idf.py set-target esp32h4.

Erase the NVRAM

Before flash it to the board, it is recommended to erase NVRAM if user doesn't want to keep the previous examples or other projects stored info using idf.py -p PORT erase-flash

Build and Flash

Build the project, flash it to the board, and start the monitor tool to view the serial output by running idf.py -p PORT flash monitor.

(To exit the serial monitor, type Ctrl-].)

Example Output

As you run the example, you will see the following log:

light bulb:

I (918) ESP_ZB_LIGHT: status: 255
I (901) ESP_ZB_LIGHT: Zigbee stack initialized
I (901) ESP_ZB_LIGHT: Start network steering
I (2611) ESP_ZB_LIGHT: Joined network successfully (Extended PAN ID: aa:98:48:01:a0:03:f7:84, PAN ID: 0x0e8b)
I (5651) ESP_ZB_LIGHT: on/off light set to 1
I (6631) ESP_ZB_LIGHT: on/off light set to 0
I (7331) ESP_ZB_LIGHT: on/off light set to 1
I (8251) ESP_ZB_LIGHT: on/off light set to 0
I (9111) ESP_ZB_LIGHT: on/off light set to 1
I (9671) ESP_ZB_LIGHT: on/off light set to 0

Light Control Functions

• By toggling the switch button (BOOT) on the ESP32-H4 board loaded with the HA_on_off_switch example, the LED on this board loaded with HA_on_off_light example will be on and off.

Troubleshooting

For any technical queries, please open an issue on GitHub. We will get back to you soon.